Boom Lift License Red Deer

Boom Lift License Red Deer - To be able to operate an aerial boom lift, operators should be certified through training which can be obtained using both practical training and classroom sessions and by attaining a boom lift license. Instruction must be given with respect to the type of aerial lift which would be utilized on the job. A License is needed for anybody who works on or operates an aerial boom lift.

Vehicle-mounted aerial devices comprise the following work vehicles: aerial ladders, extensible boom platforms, articulating boom platforms, vertical towers, and any combination of these types.

There are several basic safety regulations that apply to all boom lifts. Worker safety while within the basket is a main concern. Workers should wear a body harness and lanyard connected to the boom or basket. Never tie off to an equipment, an adjacent pole or a structure. Staff should stand on the floor of the basket, and never sit or climb on the edge of the basket. The load limitations of the manufacturer should be adhered to.

Aerial lift operators must be authorized to make use of the machines. The operator must know all the aspects of the device and should have access to the manufacturers manual that must be kept within the lift. Operators are responsible for ensuring that safety procedures are followed in operating the lift. A daily test of lift controls must be performed. Position outriggers and set brakes (if they are utilized) on a stable surface or on pads. When working on a slope, make use of wheel chocks.

Never move an aerial lift truck with an elevated boom while workers are in the basket. Articulating boom and extensible boom platforms made use of as employees carriers should have plainly marked, accessible, upper controls. Except for in emergency situations, lower controls should not be used to override upper controls unless authorization has been given by the individual inside the lift.

Do not wear tree or pole climbers shall whilst working from an aerial lift.
Do not alter the insulated part of the aerial lift.
Do inspect the booms to make sure that it is correctly cradled and the outriggers are in the stowed position prior to moving.
When operating a boom lift next to power lines, make certain that the lines are di-electrically tested based on local regulations.

Click to Download the pdf